9
This SIP bandsaw is covered by a 12 month parts and labour warranty covering failure
due to manufacturers defects. This does not cover failure due to misuse or operating
the bandsaw outside the scope of this manual - any claims deemed to be outside
the scope of the warranty may be subject to charges Including, but not limited to
parts, labour and carriage costs.
This guarantee does not cover consumables such as bearings, oil, blade, etc.
In the unlikely event of warranty claims, contact your distributor as soon as possible.
Proof of purchase will be required before any warranty can be honoured.
Note: Proof of purchase will be required before any warranty can be hon-
oured.
GUARANTEE
ELECTRICAL CONNECTION….cont
Warning: Never connect any phase wires to the earth terminal of the plug or
bosrd. Only fit an approved plug with the correct rated fuse. If in doubt consult
a qualified electrician.
Note: If an extension lead is necessary in order to reach the mains supply; The
cross section should be checked so that it is of sufficient size so as to reduce the
chances of voltage drops. Always fully unwind the lead during use.
Note: Always make sure the mains supply is of the correct voltage and the
correct fuse protection is used.
Warning: Always use a qualified electrician to wire in the 3ph bandsaw, never
wire the bandsaw without any knowledge of electrics, this is extremely danger-
ous and will cause personal injury or even death.
qualified electrician to wire in the bandsaw correctly.
The wires on the 3 phase mains lead are coloured in the following way:
Yellow / green Earth
Blue/Grey Phase
Brown Phase
Black Phase
To Next Page
Loading...
Need help?
General
