Sirman PPJ20 - 4.2 - ELECTRICAL CONNECTIONS

10
4.2 - ELECTRICAL CONNECTIONS
4.2.1 - PPJ/LCJ/PCJ with single-phase motor
The machine is outfitted with a feeding cable with a cross section area of 3x1.5
mm
2
, length 1.5m.
Connect the machine to 230V./50Hz by means of a blue CEI plug, interposing a
magnetothermic-differential switch of 10A, ∆ I = 0.03A. At this point make sure
that the grounding system works perfectly.
Furthermore check that the data shown on the serial number-technical plate (FIG.
n°5) correspond to the data on the delivery notes.
4.2.2 - PPJ/LCJ with three-phase motor
The machine is outfitted with a feeding cable with a cross section area of 5 x 1.5
mm²; length ≅ 1.5 m.
Connect the machine to the 400V./50Hz three-phase electrical network by means
of a CEI plug, interposing a magnetothermic-differential switch of 10 A, ∆I =
0.03 A.
At this point make sure that the grounding system works perfectly.
Before finally connecting the machine to the three-phase feeder line, check the
direction of rotation of the cap by pressing the START pushbutton (see FIG. n.°9)
then immediately stop it by pressing the STOP pushbutton.
The direction of rotation of the cap seen from the discharge outlet must be
counterclockwise; if the direction of rotation is not exact, invert two of the three
feeding wires in the plug or outlet (see FIG. n°8).
The three-phase motor can run with a tension of either 230 V.or 400V. If not
otherwise specified the connections are carried out for 400V.; to adapt to a three-
phase 230V. network ask for assistance from the “ASSISTANCE CENTER”.
which do not bring about its malfunctioning.
FIG. n°5 - Serial number-technical plate
7
TAB. n°1 - MEASUREMENTS AND TECHNICAL FEATURES
ATTENTION: The electrical characteristics the machine is prearranged for are
indicated by a plate (attached to the back); before connecting the machine see 4.2
electrical connection.
Model u.m. PPJ10 PPJ20 LCJ10 LCJ20 PPJ10 2V
- PP/PC
PPJ10 2V
- PP/AV
Power source Mn
Tf
230 V. / 50 Hz
230 - 400 V. / 50 Hz
Length A mm
775 880 775 880 775 775
Length B mm
470 560 470 560 470 470
Height C mm
1310 1500 1310 1500 1.310 1.310
Height D mm
1040 1190 1040 1190 1.040 1.040
Capacity kg
10 20 10 20 10 10
Revolutions r.p.m
- 275 - 150 150/300 310/460
Motor Hp
0.75 1,5 0,75 1,5 0,50/0,90 0,50/0,75
Power watt
550 1.102 550 1.102 368/338 368/552
Net weight kg
46.5 59 46.5 59 48,5 48,5
Noise level dB
≤70 ≤70 ≤70 ≤70 ≤70 ≤70
400V/50Hz