Siruba C007K - Programmable 7-Segment Display Operation; (1).Key functions in the (Normal Mode】; (2). How to access (Parameter Mode A】

- 11 -
5. Programmable 7-segment Display
(1).Key functions in the【Normal Mode】on a interlock stitch machine
(2). How to access【Parameter Mode A】：(Available parameter codes：1~46)
SP
STOP
.
No Function
Enter Value area
Motor rotation
Direction icon
No function
Presser Foot goes up
when machine stop
ON / OFF
Presser Foot goes up
after trimming
ON / OFF
Cancel Half Heeling
: No Half Heeling Function
Cancel Trimmer
: No Trimmer Function
Cancel Wiper
: No Wiper Function
Start Constant Stitch Sewing
: On (LED will light )
Special Function Display
Needle Up / Down at
machine stop
Soft Start
ON / OFF
SP
STOP
PS
STOP
PS
STOP
PS
STOP
PS
STOP
a. Under 【Normal mode】 press
□
P
key will take you into the first
parameter code【001.H】of
【Mode A】
b. Press or to get the
parameter needed. e.g.;【002 SLM】
c. Press
□
S
to enter【parameter value】
d. In this area, press
key to make value adjustment.
e. Press □
S
key to save the value.
STOP
.
.
.
.
.