Siruba FA007 - Puller Device Timing Adjustment

~11~
[llJ Puller Height Adjustment (Model 927-S/M·PL)
Adjust the height of puller 0 so that it is 0.1 to 0.2 mm high from
the
top of the needle plate.
(AdjU8ting Method)
Loosen set screw e. and move puller support 8 up or down until
puller
8 is 0.1 to 0.2 mm above the top of the needle plate.
~ Puller Device Timing Adjustment (Model FA007-264/DP)
1. With 3mm wrench to loosen the screw 8 & •
2. The timing of the feed will be starting when the
needle ia away from the needle plate about 5 or
6mm, and etoping at lOmm.
3.
After adjusting the timing, retighten the screw
0 • • .
0
From the library of: Superior Sewing Machine & Supply LLC