Page 11
CHAPTER 7:
PUTTING INTO USE:
SETTING THE TEMPERATURE.
As per Chapter 2.
EXAMPLE:
To set temperature to 10 degrees press in the following sequence: “SET” “CE” 10
“SET”
If by error the wrong number is entered, wait twenty seconds or press “CE” and
repeat the operation.
SETTING THE ELECTRONIC LITRE-METRE.
As per chapter 2.
EXAMPLE:
To set-up a deposit of 20.5 litres of water press in the following sequence: 2 0 . 5
To deposit the desired quantity of water, press the “START” button and this w ill
initiate the flow of water with relative counting on the scale visible on the display; it
is possible to stop the counting, by pressing the “STOP” button, to restart counting
press the “START” button.
At the end of the required deposit the machine automatically stops the flow of water
and the display turns to the previous set val ue and can be re used by pressing the
“START” button, if in case you want to change the value press the “CE” button and
enter the new value.
In order to obtain smaller quantities of w ater, less than a litre, press the “CE” button
and press the decimal point “.” then the value of decilitres from 1 to 9.
It is not recommenced that the machine is used to dispense less then 5 litres as the
quantity of water left in the hose can corse inaccuracy in the deposit. If small
amounts are to be deposited ensure that the hose is completely emptied and / or it is
in the same height was maintained from the previous deposit.
!
ELECTRONIC PROTECTIONS.
When over heating occurs, either due to atmospheric temperature being high or
deposits of dirt on the condenser, the compressor stops automatically and the red
indicator (located above the ON/OFF button) starts flashing.
If the cause of the over heating is accidental it will be alright to press t he “STOP”
button and restart the machine pressing the “START” button after 15 minutes.
If the cause is due to deposits of dust on the condenser, it must be cleaned before the
machine is turned on again. (See Chapter 8).
To Next Page
Loading...