SITEP PR50 - Customer Fault Finding Guide

Page 13
Customer Fault Finding:
PROBLEM ENCOUNTERED REM
E
Why will the unit not turn on ? Check if lead is plugged correctly int
o
Check the power point is turned on.
Check earth leakage sw itch is in the
o
Hold down the “ON” button o n the c
o
Why does the water tank take a long time to fill? Check that the mains water tap is ful
l
Check that the water filter is clean ?
R
Check that the water pressure is suff
i
Why won’t the unit deposit water ? Machine requires a minimum of 7 mi
n
There could be an air bubble develo
p
water have been set higher then th
e
problem make s ure that the tank is fu
l
out of the pump after by sucking at t
h
pressing the “start” button. Re enter
a
Why won’t the unit cool down the water? Is the air inlet to the condenser on the
obstructions and clean.
Check that no items are on top o f the
m
of the machine.
Ensure that the machine is given eno
u
The acceptable cooling time is 1 degr
e
Has the temperature been set correct
l
Why is the red warning light on(bell)? Is there sufficient air circulation aro
u
Is the condenser clean (see maintena
n
Turn off machine and wait for 15min
u
(see chapter 7) If switches of again ca
Why will the unit not heat up the water? Ensure that you have a model ending
Has the temperature been set correct
l
Ensure that the machine is given eno
u
If after checking these faults and the problem still exists contact either W&P Reedy or
t