Page 15
------ RISKS DANGER ! ------
A) Wrong installation of the machine
If the machine is installed in an incorrect position, (ie not horizontal), it will
result in loss of water.
Check thoroughly that the wall bracket or stand has been fastened correctly to
the wall, if it is not securely attached to the wall the machine will fall.
B) Positioning of the machine in relation to the environment and
the workplace.
The machine conforms to protection code 44IP and can therefore not be
installed in an environment where there are explosive substances in the form
of gasses.
C) Carrying and transportation of the machine.
The machine must be transported in a horizontal position and not inclined on
the side or posterior. It should always be transported on a cart and a scissors
lift used to lift the unit of the ground.
D) Objects under the machine.
The machine and / or filter might experien ce loss of water, it is advisable not
to put objects that can be damaged by water under the machine.
E) Risks relating to maintenance.
During maintenance, if the protecting panels are removed it should be done
with caution knowing that the refrigeration system is always under pressure,
and bursting one of the pipes will cause the flow of inflammable gas.
There is also an electrical risk as the machine has got a power coerced of 240
volts.
There is also a mechanical risk from the motor fan, if the covers are removed,
as this could be starting sporadically as it is electrical driven.
F) How to proceed w ith the machine.
The operator must only proceed to use machine after reading the manual
which must be available for reference at all time.
A repairer must be a professional in this field, and must be authorized to work
on this machine by W & P Reedy P/L. Before carrying out any form of
maintenance.
To Next Page
Loading...