CAUTION
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference with
the equipment is operated in its installation.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the product manual, could
cause harmful interference to radio communications. If this equipment
does cause harmful interference, the user will be required to correct the
interference. Due to the phenomena being observed and the material
properties being measured, this equipment radiates radio frequency energy
while in the active test mode. Care should be taken to ensure this radio
frequency energy causes no harm to individuals or other nearby equipment.
Information furnished in this manual by SKF USA, Inc. is believed to be accurate and reliable.
However, SKF USA, Inc. assumes no responsibility for the use of such information or for any
infringements of patents or other rights of third parties that may result from its use. No
license is granted by implication or otherwise under any patent rights of SKF USA, Inc.
SKF USA, Inc. assumes no liability for damages consequent to the use of this product. No
part of this document may be reproduced in part or in full by any means such as
photocopying, photographs, electronic recording, videotaping, facsimile, etc. without written
permission from SKF USA, Inc. Fort Collins, Colorado.
Note on software
While the Baker AWA-IV is a Microsoft Windows® based instrument, it is not a computer,
which any software available in the market should be installed. The installed applications and
Windows® configuration are set up to operate the Baker AWA-IV hardware. Modifications to
this setup may cause unit malfunction.
ii PUB CM/I4 71-015 EN V13.2 Static Motor Analyzer—Baker AWA-IV User Manual
Notices
To Next Page
Loading...
Need help?
General
