SKF LMC 301 series Installation Guide

Quick Setup/Installation Guide for Lubrication Monitor Controller LMC 301
951-150-029-EN
15
System configuration
Key Display Description
System configuration - Amount of pumps, Pump settings, Set Params to Default
- only in Supervisor password level
1
)Requirements: Supervisor password level is
enabled.
• Use <down/up arrow key> to select System
configuration.
• Press <control key OK>.
)You will enter the System configuration menu.
)You will be asked "Lubrication will be
stopped- Continue?"
• Press <control key Yes>.
)You will enter the System configuration menu.
The following settings can be made:
o Amount of pumps
o Setting the pumps
o Set Params to Default
Main menu
Login settings
User settings
Device settings
Pump 1 Timings
System configuration
Information
System configuration
Lubrication will be stopped
Continue?
Yes
No
System configuration
Amount of pumps
Setting the pump
Set Params to Default
ATTENTION!
SKF Service menu
This level is password-protected and can-
not be accessed from the operator level or
the Local Admin level. Settings can be made
only in the Supervisor password level.
All essential controller and system settings for
are made in the
System configuration menu level.
These settings can and may only be made
by SKF Service.
5.2.4 Menu structure for system configuration
Select
Back
Back Ok

SKF LMC 301 series Specifications

General

Brand	SKF
Model	LMC 301 series
Category	Controller
Language	English