----
Adjusting
----...
r screw
A007
004 002
Replace adjusting screw caps after ad-
justment.
Bulb
Replacement
If the headlamp bulb
is
burnt, open
hood and unplug the connector from
the headlamp. Remove the rubber boot
and unfasten bulb retainer clips. Detach
the bulb and replace.
Installation
is
the
reverse
of
removal
pro-
cedure .
....,-CAUTION
: Never touch glass
T portion of
an
halogen
bulb
with
bare fingers, it shortens it's operating
life. If
by
mistake glass
is
touched
clean it with a glass cleaner that will
not leave a film
on
the
bulb.
Retainer clips
A002
004 009
If taillight bulb
is
burnt, unfasten the two
screws holding the lens and remove.
Replace bulb and install lens.
Do
not
over tighten lens retaining screws.
42
•
WARNING
:Always
check light
operation after
bulb
replacement.
Wiring
harnesses, cables
and
lines
Ensure each routing
is
well secure with
proper fasten device (locking
tie,
clip,
grommet, etc.) away from hot or rotat-
ing components.
General
Inspection
Check the electrical wiring and com-
ponents, retighten loose connections.
Check for stripped wires or damaged in-
sulation. Thoroughly inspect the vehicle
and tighten loose bolts, nuts and link-
age.
Inspect skis and ski runners for
wear.
To Next Page
Loading...
Need help?
General
