skike v7 FIX all models
8 2014
D.4 Quick release
Correct locking of a quick release is performed as follows: When the
wheel and quick release is in place with the nut on the end, the
tensioning lever is then wound in a clockwise direction. The correct
setting is achieved by first winding the tensioning lever around
effortlessly at an of angle of 90 degrees to the plane of the wheel until if
becomes close to being tight. Then firmly push the lever all the way down
until it rests as flat as possible on the skike frame or fork. By adjusting
the wound up postion of both the nut and the lever, you can finish with
level being locked firmly in place. If necessary the flattened lever can be
wound a little more when it is in the locked down position. The final
position of the lever should be facing backwards, to minimise the risk of
oncoming items being caught inside the lever.
D.5 Wheels with reverse control mechanism
The procedure is the same for wheels with and without a reverse control
mechanism.
To Next Page
Loading...