Manual-English
Version 1.4.0303.2016 13
For small feet of the heel strap is to use the foot as far as it goes in the
center of the skike position.
F.1.1 Wheelbase setting
Loosen and remove screw with attached tool (1.b.)
●
Put front weels to the desired position (1.a or 1.c)
●
Insert screw (1.b.) and fasten
●
Proof directional stability of the skike (see section H.2)
●
C.1.2 Setting shoe size
●
The heel belt determines the position in skike
●
F.1.2 Setting shoe size
The heel belt determines the position in skike
●
When the front wheel is already in the correct position, make sure to
●
stand close to the front wheel while adjusting the heel belt. Please
consider that the brake can still be adjusted sufficiently far to the rear (
see brake adjustment section: D).
The skike has a wing nut on one side (5.c). By loosening the wing nut
●
and moving the heel strap (6), the position of the foot is also changed.
The coarse adjustment of the heel strap can be made in each case on
the opposite heel lift fixture means of attachment to differently
positioned holes.
Note: The distance between the heel (shoe) and rear wheel ,
however, should never be less than 10mm
To Next Page
Loading...