skike v7 FIX all models
12 2014
and a damp cloth to avoid adverse effects of any kind that may be
incurred by dirt and moisture.
E.2 Screws, nuts, quick releases, joints
A regular review of all threaded connections is required to prevent
greater damage and maintenance-related accidents!
Self-locking nuts must always be replaced after they have dissolved and /
or were dissolved to be replaced. The locking effect is guaranteed only
for a proper first use.
We recommend changing of all self-locking nuts at least once a
year and to replace them with new, original skike spare parts.
Quick releases can be loosened and tightened again more often without
loosing their securing capabilities, but the nuts are subject to progressive
wear.
We recommend replacing all quick releases with new, original
skike spare parts after about 40-50 uses for security reasons.
Keep all joints free of dirt. Pay attention to the wear of the plastic disc
between the two metal surfaces. Regularly check the correct position of
the hinge screws. Never replace only one joint, always replace both joints
at the same time on a single skike! The replacement of only one joint on
a skike places a resulting much greater burden of both joints and
therefore inevitably leads requiringmore frequent changes of both joints.
We recommend with normal, regular use of your skikes to
replace all joints once a year with new, original skike spare
parts. Joints are subject to wear. Regular replacement for your
safety guarantees a consistent and high riding pleasure.
F. SETTING, BUCKLING- AND
UNBUCKLING
F.1 Wheelbase and basic setting
Front position, standing position, and brake adjustment must be
coordinated so that optimal function of skike can be achieved. The
distance from the heel to the rear wheel should not be less than 10mm.
To Next Page
Loading...