EasyManua.ls Logo

SKIKE V7 FIX - Straping in and unstraping

SKIKE V7 FIX
27 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
skike v7 FIX all models
14 2014
F.2 Straping in and unstraping
F.2.1 Straping
Before you put on the skike, make sure that between calf and calf shell
there is a fabric (pants, socks or stocking)
The new foot belts with fixation can be easily opened and reared until
they stop.
Beginner and less experienced skikers should start by sitting down to
put the skikes on. Begin on flat ground. First, slide the foot below the
two over foot straps when the skike is on the ground, then slide the foot
backwards into the heel strap (6).
Tighten the straps and start with the calf shell (5) , especially in the
absence of seat firmly on the stand is already loose after tightening of
the calf strap (5) guarantees.
The second strap to tighten is the Middle strap (3.b), pressing on the
lying down holding strap on the shoe. Avoid shoe node or the like below
the belt. Before tightening, make sure that the strap end with the pin
has been pulled all the way through the retaining slot, to have the pin
pressing up against the retaining slot.
Note: the central aperture (4.d) is not intended to pull bands,
but can be used for it in certain special cases, for example, to
give a little foot better support or comfort.
Lastly tighten the front strap (3.a).