22
TROUBLESHOOTING
WARNING
Turn switch “OFF” and always remove plug from the power source before
trouble shooting.
Trouble Problem Remedy
Will not start Power cord is not plugged in. Plug in.
Fuse or circuit breaker tripped. Replace fuse or reset tripped circuit
breaker.
Cord damaged. Have cord replaced by an Authorized Skil
Service Center or Service Station.
Burned out switch. Have switch replaced by an Authorized
Skil Service Center or Service Station.
Tool does not
come up to
speed
Extension cord too light or too
long.
Replace with adequate cord.
Low house voltage. Contact your electric company.
Excessive
vibration
Tile blade out of balance. Discard tile blade and use different one,
see page 16.
Tile blade bolt not tight. See “Tile Blade Installation”, page 16.
To Next Page
Loading...
