11
7
! never let the vacuum cleaner hose interfere with
the lower guard or the cutting operation
7
- connect plug to power source
! ensure that the saw teeth are not engaged into
the workpiece
! the tool should run at full speed before the blade
enters into the workpiece
! while working, always hold the tool at the
grey-coloured grip area(s)
trigger T
! ensure that the blade has come to a complete
standstill, before you lift the tool from the
workpiece
APPLICATION ADVICE
ensure minimum splintering
8
9
Adjusting parallel guide
- loosen knob W
- tighten knob W
0
- set desired cutting depth
as hinge-point
! never pull tool backwards
!
workbench
! set cutting depth so that you cut through panel
and not through support
this guide
MAINTENANCE / SERVICE
3 clean
! disconnect the plug before cleaning
power tools
- send the tool undismantled
ENVIRONMENT
Do not dispose of electric tools, accessories and
packaging together with household waste material
implementation in accordance with national law,
@
disposing occurs
DECLARATION OF CONFORMITY
60745, EN 61000, EN 55014, in accordance with the
2011/65/EU
Technical file at
4825 BD Breda, NL
¹ÊÁÂÆιƼ½ÊÇǾ¼½Æ
ȽʹÌÁÇÆËŵÆ¿Áƽ½ÊÁÆ¿
ÍÊÇȽƓˁ˅ʿ˂ʽ¼¹Ɠ
Ĺ¾ÁÂÿʹ¹¾
ÈÈÊÇιĹƹ¿½Ê
12.08.2013
NOISE/VIBRATION
To Next Page
