What to do if my Skil 5485 will not start?
If your Skil Saw won't start, possible causes include: the power cord isn't plugged in (plug the saw in); a tripped fuse or circuit breaker (replace the fuse or reset the breaker); a damaged cord (inspect and replace if necessary at an authorized service center); a burned-out switch (have it replaced at an authorized service center); or the safety switch is engaged (disengage the safety switch).
Why does my Skil 5485 Saw cut bind, burn, and stall when ripping?
If your Skil Saw cut binds, burns, and stalls motor when ripping, the causes and solutions are: * A dull blade with improper tooth set. Discard the blade and use a different one. * A warped board. Make sure the concave or hollow side is facing 'DOWN' and feed slowly. * Blade binds. Assemble the blade and tighten the Vari-Torque clutch. * Improper workpiece support. Clamp or support the workpiece.
Why is my Skil 5485 Saw blade not coming up to speed?
If the blade of your Skil Saw is not reaching the correct speed, this could be due to an extension cord that is too light or too long (replace it with an adequate cord) or low house voltage (contact your electric company).
What to do if Skil 5485 Saw has excessive vibration?
Excessive vibration in your Skil Saw can be caused by: * A blade that is out of balance. Discard the blade and use a different one. * A workpiece that is not clamped or supported properly. Clamp or support the workpiece.
Why Skil 5485 Saw blade is slipping?
If the Skil Saw blade is slipping, it means that tool does not cut workpiece. To fix this, assemble the blade and tighten the Vari-Torque clutch.
Essential safety guidelines for operating power tools, covering work area, electrical, and personal safety.
Specific safety rules and procedures for operating circular saws.
Focuses on kickback causes, prevention, and proper lower guard function.
Covers GFCI, chemical exposure, tool usage, and maintenance safety.
Defines various symbols used on the tool and in the manual for clarity.
Lists specifications and capacities for different SKIL circular saw models.
Step-by-step guide for assembling the tool and attaching the blade.
Explains the function and importance of the Vari-Torque Clutch for safety.
How to adjust settings and use safety features for operation.
Using guides and techniques for various cuts like plunge and sheet cutting.
Guidance on tool care, lubrication, and component replacement.
Information on recommended accessories and proper extension cord selection.
Diagnosing and fixing common problems with the power tool.
Details the warranty terms and conditions for SKIL power tools.
To Next Page
General
