27
TROUBLESHOOTING
Problem Cause Remedy
Tool will not start. 1. Power cord is not plugged
in.
1. Plug in the power cord.
2. Fuse or circuit breaker
tripped.
2. Replace fuse or reset tripped circuit
breaker.
3. Cord damaged. 3. Have cord replaced by an
Authorized SKIL Service Center or
Service Station.
4. Switch not functioning. 4. Have switch replaced by an
Authorized SKIL Service Center or
Service Station.
Tool does not come
up to speed.
1. Extension cord too light or
too long.
1. Replace with adequate cord.
2. Low house voltage. 2. Contact your electric company.
Belt/disc does not
rotate while motor is
running.
1. Drive belt is too loose or
broken.
1. Have the drive belt tighten or
replaced by an Authorized SKIL
Service Station.
To Next Page
Loading...
