Skil SRT1039 User Manual

WARNING: To reduce the risk of injury, the user must read and understand the
Owner’s Manual before using this product. Save these instructions for future reference.
AVERTISSEMENT : Afin de réduire les risques de blessure, l’utilisateur doit lire et
comprendre le guide d’utilisation avant d’utiliser cet article. Conservez le présent guide
afin de pouvoir le consulter ultérieurement.
ADVERTENCIA : Para reducir el riesgo de lesiones, el usuario debe leer y comprender
el Manual del operador antes de utilizar este producto. Guarde estas instrucciones para
consultarlas en caso sea necesario.
Owner’s Manual
Guide d’utilisation
Manual del propietario
For Customer Service
Pour le service à la clientèle
Servicio al cliente
Router Table
Table à Toupie
Mesa de Fresado
1-877-SKIL-999
OR
www.skil.com
Model/ Modelo/ Modèle: SRT1039

Skil SRT1039 Specifications

General

Brand	Skil
Model	SRT1039
Category	Indoor Furnishing
Language	English

Summary

General Safety Warnings for Bench Tools

Specific Safety Warnings for the Router Table

Improper Fence Location and Workpiece Feed

Important Information about Extension Cords

Grounding Instructions

Symbols

Safety Symbols

Explains safety symbols and their importance for hazard recognition.

Symbols (Certification Information)

Parts List

Getting to Know Your Router Table

Specifications

Router Table Setup

Attaching the Legs to the Table

Details on how to attach the two table legs to the router table base.

Removing the Quick-Clamp Router Mounting Plate

Instructions for detaching the router mounting plate from the table base.

Attaching the Quick-Clamp Mounting Plate to SKIL Routers

Steps for mounting the quick-clamp plate to SKIL routers for the table.

Installing the Quick-Clamp Mounting Plate and Router to the Router Table

Procedures for installing the router mounting plate and router onto the table.

Installing the Insert Ring

Guide on how to select and install the correct tabletop insert ring.

Attaching the Fence Assembly to the Tabletop

Instructions for attaching the pre-assembled fence to the tabletop.

Attaching the Miter Gauge

Steps for attaching and adjusting the miter gauge to the table.

Attaching the Featherboards

Details on how to attach featherboards to the fence and tabletop.

Permanent Attachment to a Workbench

Instructions for securing the router table to a workbench.

To Adjust the Cutting Depth

Guide on adjusting the router's cutting depth via the table.

Router Table Operation

Switch Box Operation

Explanation of how to use the integrated safety switch and receptacles.

Using a Vacuum

How to connect and use a vacuum with the router table.

Toolboxes

Information on the router table's built-in toolboxes for storage.

General Routing Operations

Using Fence

Moving the Fence Forward and Backward

How to adjust the fence position forward or backward.

Sliding the In-feed and Out-feed Fence Sideways

Instructions for sliding the in-feed and out-feed fences sideways.

Setting up Out-feed Fence for Joining

How to set up the out-feed fence for joining operations.

Using Featherboards

Guidance on positioning and using featherboards for workpiece control.

Using Starter Pin

Using Miter Gauge

Maintenance

Service

General advice on using identical SKIL replacement parts for servicing.

Cleaning

Instructions and warnings for cleaning plastic parts and tool.

Limited Warranty of SKIL Consumer Corded Power Tools