12
PARTS LIST
Refer to parts list below.
WARNING
If
ANY
of the parts are missing, DO NOT attempt to assemble, install, or
use your router table until the missing parts have been found or replaced
and your router table has been properly and correctly assembled per this manual.
•
For missing parts or technical assistance, call 1-877-SKIL-999.
•
In order to simplify handling and to minimize any damage that may occur during shipping,
your router table comes mostly assembled. Repositioning of some parts will be required.
•
Separate all parts from the packaging materials and check each part against the illustrations
and the parts list to make sure that all parts have been included. Do this before discarding
any of the packaging material.
Item Description Quantity
A
Router table assembly (including 6pcs pre-assembled bolts and 4pcs pre-
assembled screws)
1
B
Left and right table legs 1
C
Fence assembly 1
D
Featherboard assembly for fence 1
E
Featherboard assembly with a slide bar for tabletop surface 1
F
Miter gauge assembly 1
G
Insert ring set (3 rings per set)
G-1
Insert ring w/ Ø 11/16” (17.5mm) hole 1
G-2
Insert ring w/ Ø 1-1/4” (32mm) hole 1
G-3
Insert ring w/ Ø 1-3/4” (44.5mm) hole 1
H
Starter pin 1
I
5mm combination wrench (hex/ Phillips) 1
A
Router Table Assembly
4pcs Screws
6pcs Bolts
C
B
D
To Next Page
Loading...
