What to do if my skilsaw SPT88 will not start?
If your Skilsaw Saw won't start, there are several possible causes: * Ensure the power cord is properly plugged into a functioning power outlet. * Check the fuse or circuit breaker and replace the fuse or reset the breaker if tripped. * If the cord is damaged or the switch is burned out, have them replaced by an Authorized SKILSAW Service Center or Service Station.
Why is my skilsaw SPT88 Saw blade not coming up to speed?
If the blade on your Skilsaw Saw isn't reaching full speed, it could be due to: * Using an extension cord that is too light or too long. Replace it with an adequate cord. * Low house voltage. In this case, contact your electric company.
What to do if my skilsaw Saw has excessive vibration?
Excessive vibration in your Skilsaw Saw can be caused by: * An out-of-balance blade. Discard the blade and use a different one. * The saw not being securely mounted to the stand or workbench. Tighten all mounting hardware. * A loose arbor nut. Refer to the 'Removing and Installing the Blade' section in the 'Assembly' section for instructions.
How to fix a shadowlight that is not working on my skilsaw SPT88 Saw?
If the shadowlight on your Skilsaw Saw is not working or is dim, consider the following: * The shadowlight cover may be covered in sawdust or wood pitch. Clean it with compressed dry air or wipe it with a damp cloth. * Ensure the shadowlight on/off switch is activated (turned on). * If the switch is not functioning, have it replaced by an authorized SKILSAW Service Center or Service Station.
Defines safety alert symbols (Danger, Warning, Caution) for hazard severity.
Guidelines for safe work environment, alertness, and using PPE.
Proper grounding, cord care, and protection against electric shock.
Details on grounding, outlet requirements, and cord connection safety.
Specific safety precautions for operating miter saws, including workpiece support.
Details the meaning and interpretation of various safety and operational symbols.
Procedures for safely removing and installing the saw blade.
How to align the blade square to the table for accurate cuts.
How to calibrate the miter detent system for accurate angle selection.
Guidance on correct posture and hand placement for safe cutting.
Lists common problems and remedies for a saw that fails to start or reach speed.
To Next Page
General
