11/23
4. Operational condition
Operational condition is shown on the display as the
first symbol of the bottom line (Fig. 1). The controller
can be in one of four statuses:
The controller is energized, however, all activities
are turned off.
S STOP - The controller is turned on and it is in the
S-stop condition. Output power voltage is blocked,
the feeder is idle. Viewing and modifications of all
parameters and saving the parameters in the memory
is possible.
R RUN (operation)- The controller is turned on and it
is in the R-run condition. Output voltage is
connected and the feeder is vibrating. Viewing and
modifications of all parameters are possible.
W WAIT - The controller is turned on and it is in the
W-wait condition. Output power voltage is blocked,
the feeder is idle. The controller waits for
a signal from sensors or from a master control
system. Viewing and modifications of all parameters
are possible.
5. Turning ON
Controller turning on can be carried out using two
methods:
a) Turning on is to be carried out by depressing the
button
on
/
off
. Turning off can be carried out by
depressing the button again.
This method of turning on is suitable in case that
the controller operates independently without link
to any other electric equipment.
Caution! Internal circuits of the controller
are still energized and for that reason, such
turning off cannot be considered as safe
disconnection from the mains! This condition is
indicated on the display with the symbol .
b) Turning on is carried out automatically after power
supply voltage connection. For this purpose, it is
necessary to set the parameter A36 to “automatic”.
This method of turning on is suitable if controller
power supply is connected through a connecting
To Next Page
Loading...