20/23
8.26. A39 Language
Language selection.
English – Always available.
Czech – Is delivered if another language version has
not been ordered. As standard Russian or German
can be ordered or another language agreed on.
8.27. A40 Information
For more information about this product, visit our
Internet pages http://www.skipala.cz
8.28. A41 Password
Typing the password temporarily unlocks blocked
parameters.
The password is delivered by the firm as a 3-digit
number 108 and can not be changed. Its purpose is to
protect the controller against accidental overwriting
of locked parameters. The password cannot be typed if
it is changed or the controller disconnected.
8.29. Factory settings
If there are complications with controller, RESTART it
to reset the factory settings of all parameters. RESTART
as follows:
Disconnect the controller from the supply network and
wait at least 60 seconds to discharge condensers
(the character disappears on the display)
press the
enter
button and hold it down
connect the controller to the supply network
release the
enter
button
The parameter values of the factory settings are given
in the table (Fig. 10).
To Next Page
Loading...
Need help?
General
