Radio4
If you have switched off the radio by withdrawing the ignition key, the radio
switches on again once the ignition is on.
Audio settings
– Select the desired parameter after pressing the button and then
the station key .
– Set the desired value by turning the rotary/push knob .
You can select the following parameters:
• TREBLE - treble setting;
• MIDTONE - midtone setting;
• BASS - bass setting;
• LOUD - in case of low volume level, this function reinforces the range of bass
and treble frequencies;
• MONO.
The selection OFF of the stereo coder is automatically regulated. If the signal is
strong, a stereo reception is made.
The selection ON - under certain circumstances the reception of the stereo signals
can be distorted, even if the signal is strong. e.g. while driving through urbanization.
The stereo coder is deactivated and the reception quality is clearly improved by
activating the force Mono reception.
Note
The text on the display goes out 10 seconds after the last press. After pressing any
button, except the station keys , the setting is finished and the selected values
are stored.
Second level of the audio settings
– You can call up the second level of the audio settings by pressing the
button and by subsequently pressing the station key
.
You can select between the following parameters:
• BALANCE - setting of the volume ratio between the right and left side;
• FADER - setting of the volume ratio between the front and the rear.
Third level of the audio settings
– You can call up the third level of the audio settings by pressing the
station key
again.
You can select between the following parameters:
GALA
Your radio increases automatically its volume with the increasing vehicle speed. A
higher setting value results in a stronger volume increase.
PDC VOL
If your vehicle is equipped with “parking aid”, the volume is automatically
decreased to a pre-defined value, when the “parking aid” is active.
PH VOL
If your vehicle is equipped with a handsfree system, you can set the desired volume
of the mobile phone calls.
TA VOL
The setting of the minimum volume for receivable traffic reports.
The volume is increased by the value set by this parameter, if its current value is
lower. Otherwise the volume is not changed.
To Next Page
Loading...
