›
Tap the function surface
Network Settings
.
›
Select the data provider.
If your data provider is not available in the list, ask your provider whether one
of the displayed providers can be used.
›
To check the network settings and adapt them in accordance with your data
provider's instructions if necessary, tap on the
Network settings
function sur-
face.
The usage settings for data connection via SIM card can be configured in the
→ →
Network
→
Data connection:
.
Manual configuration of the data connection network (APN access point)
If the data connection is not established automatically or if you wish to config-
ure the network (APN access point) manually, proceed as follows.
›
Tap the
sensor field and then the function surface
→
Network
→
Network
settings
.
›
Carry out manual configuration in accordance with your data provider's in-
structions.
›
To save the configured values, tap the
Store
function surface.
Change PIN code
›
In the Telephone main menu, tap on function surface
→
PIN setup
→
Change
PIN
.
›
Enter the new PIN code and confirm.
Remove SIM card
›
Press on the inserted SIM card.
The SIM card “jumps” into the eject position.
›
Remove the SIM card from the slot.
CAUTION
■
When inserting a SIM card of the incorrect size, there is a risk of damage to
Infotainment.
■
Avoid using a an adapter for the SIM card as the SIM card may fall out while
driving due to vehicle vibrations - There is a risk of damage to the external
module.
■
If you let the SIM card protrude out from the slot, then it may fall out of the
slot while driving due to vehicle vibrations.
Note
If a SIM card is inserted in the external module and the option to use the SIM
card telephone services is selected, the currently connected telephones will be
disconnected. You can then only connect the additional telephone to the info-
tainment system.
rSAP
Applies to Infotainment Columbus with the SIM card slot in the external mod-
ule.
The Bluetooth
®
profile RSAP (remote transmission of SIM data) also allows, in
contrast to Bluetooth
®
profile HFP the use of data services of the connected
telephone (if this profile is supported by the telephone and data services are
enabled in this telephone) » page 179.
The use of Bluetooth
®
profile RSAP requires the telephone function of the ex-
ternal module to be switched on.
Switching on and off
›
In the Telephone main menu, tap on the function surface,
→
"Business" tele-
phone “interface”
.
The pairing and connection process takes place in the same way to the Blue-
tooth
®
profile HFP » page 169.
If the rSAP profile is supported by the telephone to be connected, then the in-
fotainment system tries to connect using this profile with priority. Depending
on the telephone, it is possible to block or release the connection using an
rSAP profile in the telephone.
Note
■
If a SIM card is inserted in the external module, it is not possible to connect
the telephone to Infotainment using the rSAP profile.
■
If Infotainment is connected to an external device via Apple CarPlay or
Android Auto, then using the data connection via rSAP is not possible.
Telephone functions
Enter telephone number and select
Enter a telephone number and dial
›
In the Telephone main menu, tap the function surface
.
172
Infotainment
To Next Page
Loading...
