Storing the tyre pressure values and Infotainment display
Fig. 312
Button for storage/example of
the screen: a change in the front
left tyre pressure is indicated
Read and observe and on page 257 first.
Procedure for storing the tyre pressure values
›
Inflate all the tyres to the specified pressure.
›
Turn on the ignition and switch on Infotainment.
›
In the infotainment system, in menu
/
tap on function surface
Tap
→
Vehicle status
.
›
Use the function surfaces
to select menu item Tyre Press. Loss Indicator.
›
Tap the function surface
» Fig. 312.
In addition, follow the instructions that appear on the screen.
A message on the screen informs about the storage of the tyre pressure val-
ues.
Note
When the warning light appears in the instrument cluster, the affected tyre
can be displayed on the infotainment system » Fig. 312.
Towing device and trailer
Hitch
Introduction
The maximum trailer nose weight when towing a trailer is 90 kg. Other data
(e.g. shown on the rating plate of the hitch) only provides information about
the test values of the device.
WARNING
Do not use the towing device if it is damaged or if there are parts missing.
Swinging in and out the tow bar
Fig. 313
Ball rod: Swivel out/in
Read and observe on page 258 first.
The pivotable tow bar cannot be removed. Its correct latching in both posi-
tions is indicated by a warning light.
Swing out the tow bar
›
Pull the release lever
A
in the direction of arrow
1
» Fig. 313 » . The tow
bar pivots in the direction of arrow
2
and the warning light beside the han-
dle flashes red.
›
Allow the handle
A
to retract slowly and check if this is properly seated in
the starting position.
›
Press the tow bar in the direction of the arrow
2
, until it audibly clicks into
place. The warning light lights green.
258
Driving
To Next Page
Loading...
