Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
• The gasket ring -arrow- in the flange of the propshaft must not
be damaged when removing and installing. If the sealing ring
is damaged, the propshaft must be replaced.
– Install the propshaft on the flange of the four-wheel drive clutch
in such a way that the markings -arrows- are on the same line.
– Only screw down intermediate bearing after tightening the
propshaft.
– Screw the pendulum support with new screws -arrow B- and
-arrow C- onto the gearbox ⇒ Engine; Rep. gr. 10 .
– Install exhaust system and align free of stress ⇒ Engine; Rep.
gr. 26 .
– Install the noise insulation ⇒ Body Work; Rep. gr. 50 .
• If droning noises occur while driving, the following must be
observed.
• Unscrew the propshaft with flexible disk with oscillation damp‐
er from the flange of the four-wheel drive clutch and screw on
again offset by a hole.
• If the droning noises are still audible, the propshaft with flexible
disk with oscillation damper must be removed from the flange
of the four-wheel drive clutch again and offset by another hole.
Tightening torques
♦ ⇒ “1.1.2 Summary of components - propshaft, Octavia II as of
06/2007”, page 19
1.6.3 Removing and installing rear flexible
disk, Superb II
Removing
Special tools and workshop equipment required
♦ Engine/gearbox jack , e.g. -V.A.G 1383/A-
♦ Counterholder - T10172-
• Work on the propshaft should be carried out on a two-pillar lift
platform.
• Before the removal, mark the position of all parts to each other.
Carry out the installation again in the same position, otherwise
the imbalance is too great, damages to the bearing and hum‐
ming noises could occur.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
54 Rep. gr.39 - Final drive - rear differential
To Next Page
Loading...
