Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
3 Repair instructions
⇒ “3.1 Rules of cleanliness”, page 5
⇒ “3.2 General repair instructions”, page 5
⇒ “3.3 Seals and sealing rings”, page 6
⇒ “3.4 Screws, nuts”, page 6
3.1 Rules of cleanliness
♦ Thoroughly clean the connection points and their surroundings
before disconnecting.
♦ Open the open lines and connections immediately with a clean
plug, e.g. from the screw plug set for engine - VAS 6122- .
♦ Only install clean parts: remove spare parts from their wrap‐
ping immediately before fitting.
♦ Make sure no dirt gets into the gearbox when the gearbox is
open.
♦ Always replace paper gaskets after disassembly. Completely
remove old gaskets and thoroughly clean sealing surfaces.
♦ Place removed parts on a clean surface and cover them to
prevent them from getting dirty. Use sheeting and paper for
this purpose. Use lint-free cloths!
♦ Carefully cover or close opened components if the repair is not
completed immediately.
♦ Protect electrical plug connections from dirt and moisture and
only connect them when dry.
3.2 General repair instructions
A number of general notes on the individual repair procedures,
which are valid for this particular workshop manual, are summar‐
ised here.
To ensure flawless and successful gearbox repairs, the greatest
care and cleanliness as well as the use of good and proper tools
are essential.
Also note the basic rules on safety when performing repair pro‐
cedures.
Targeted fault finding, Vehicle self-diagnosis and Measuring
method
• Before repairing the four-wheel drive clutch, the cause of the
error must be identified as accurately as possible in the Tar‐
geted fault-finding mode ⇒ Vehicle diagnostic tester.
Special tools
For a complete list of special tools used in this workshop manual,
see ⇒ Workshop equipment and special tools .
Oil
The final drive and the four-wheel drive clutch have separate oil
circulation systems.
Filling capacity ⇒ “4.2 Filling capacity”, page 10 .
Installation location overview of oil drain plug and check screw
⇒ “5.1 Installation location overview - drain plug and check screw”,
page 90 .
• Do not mix any additives in the oil.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
3. Repair instructions 5
To Next Page
Loading...
