Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
2.2 Removing and installing the rear final
drive
⇒ “2.2.1 Removing and installing final drive 02D/0AV, Octavia II”,
page 65
⇒ “2.2.2 Removing and installing final drive 0BR, Octavia II, Su‐
perb II, Yeti”, page 70
2.2.1 Removing and installing final drive 02D/
0AV, Octavia II
Special tools and workshop equipment required
♦ Engine/gearbox jack , e.g. -V.A.G 1383A-
♦ Counterholder - T10172-
♦ Adapter - T10172/5-
Removing
– Remove luggage compartment floor covering.
– Remove the two rubber plugs -arrows A- in the luggage com‐
partment floor.
– Release both screws -arrow B- for the rear final drive to the
assembly carrier from the top through the holes in the luggage
compartment floor. Thus, the socket insert - T10061- can be
used.
– Raise vehicle.
– Remove the rear silencer ⇒ Engine; Rep. gr. 26 .
– Tie up pre-exhaust pipe.
– Remove mounting bracket of exhaust system from assembly
carrier ⇒ Engine; Rep. gr. 26 .
NOTICE
Risk of damage to the decoupling element of the exhaust sys‐
tem.
The decoupling element must not be bent or kinked by more
than 10°.
– Do not load the decoupling element with tensile stress.
– Do not bend the decoupling element excessively.
– Remove the heat shield below the propshaft.
– Remove the heat shield -2- below the propshaft, to do so re‐
lease the screws -1-.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
2. Final drive 65
To Next Page
Loading...
