Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
2 Final drive
⇒ “2.1 Summary of components - final drive”, page 63
⇒ “2.2 Removing and installing the rear final drive”, page 65
2.1 Summary of components - final drive
⇒ “2.1.1 Summary of components - final drive 02D/0AV, Octavia
II”, page 63
⇒ “2.1.2 Summary of components - final drive 0BR, Octavia II,
Superb II, Yeti”, page 64
2.1.1 Summary of components - final drive 02D/0AV, Octavia II
The -arrow- shows the direction of travel.
1 - Assembly carrier
2 - Nut
❑ 4 pieces
❑ Tightening torque ⇒
Chassis; Rep. gr. 42
❑ Assignment ⇒ Electron‐
ic Catalogue of Original
Parts
3 - Screw
❑ 4 pieces
❑ for cross member Pos. 4
at assembly carrier
Pos. 1
❑ Assignment ⇒ Electron‐
ic Catalogue of Original
Parts
4 - Cross member
❑ is not applicable for the
steel assembly carrier
❑ Assignment ⇒ Electron‐
ic Catalogue of Original
Parts
5 - Screw
❑ Tightening torque ⇒
Chassis; Rep. gr. 42
❑ for drive shaft to rear fi‐
nal drive
6 - Drive shaft
❑ removing and installing
⇒ Chassis; Rep. gr. 42
7 - Rear final drive
❑ Removing and installing
⇒ “2.2 Removing and installing the rear final drive”, page 65
❑ Replace the rubber-metal bearing ⇒ “3.2 Removing and installing rubber-metal bearing”, page 79
8 - Stop washer
❑ fit to the rubber-metal bearing ⇒ “3.2 Removing and installing rubber-metal bearing”, page 79
9 - Screw
❑ 3 pieces
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
2. Final drive 63
To Next Page
Loading...
