Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
• Before the removal, mark the position of all parts to each other.
Carry out the installation again in the same position, otherwise
the imbalance is too great, damages to the bearing and hum‐
ming noises could occur.
• Do not bend the propshaft, only store extended and transport.
• When removing, do not let the propshaft »hang«, always sup‐
port it.
• Always remove or mount the propshaft horizontally from the
centering stud.
– Remove noise insulation ⇒ Body Work; Rep. gr. 50 .
– Remove the rear part of the exhaust gas system ⇒ Engine;
Rep. gr. 26 .
– Loosen screws -arrows- for center bearing about 3 turns.
– Support propshaft with engine/gearbox jack e.g. -V.A.G
1383A- (as an aid, e.g. use a wooden wedge)
– Check if a marking (colour point) is present on the flexible disk/
oscillation damper and on the flange of the four-wheel drive
clutch -arrows-. If not, mark the position of the flexible disk/
oscillation damper and the flange on the four-wheel drive
clutch to each other -arrows-.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
1. Propshaft 59
To Next Page
Loading...
