SKS Germany COMPIT/E - Page 25

GERMANY
Mounting the COMPIT/E and COMPIT/E+ on and removing them from the bicycle’s handlebar
25
If the screws are not tightened evenly when mounting the COMPIT/E on the bicycle,
the COMPIT/E may come loose from the bicycle and cause injury.
➤When mounting the COMPIT/E, tighten the screws evenly,
alternating between them.
CAUTION
!
!
➤ Mount the COMPIT/E on the handlebar with a torque wrench. To do so, tighten the screws (4) evenly
(alternating between them) using the torque (1 Nm) indicated on the clamping arms.
Proceed as follows to remove the COMPIT/E from the bicycle’s handlebar:
➤ Loosen the screws.
➤ Remove the COMPIT/E from the bicycle’s handlebar using the clamping arms.