93
Important information for customers with a single satellite
feed installation
Do you have a Single Satellite Feed like this?
After installation of your Sky±HD box you may see some incomplete information or
error messages on screen. Don’t worry, it’s easy to fix – just follow these instructions
to switch the Single Feed Mode to ON.
Switching the Single Feed Mode to ‘ON’
1. First, ensure that the satellite feed is connected to Dish Input 1 on the back
of your set top box.
2. Press services on your remote control to highlight Options in the Top Menu,
then the right arrow once so that Settings is highlighted.
3. Now press select to highlight the Picture tab.
4. Press 0, 1, select in quick succession to enter the Installer menu.
5. The Set Up tab will then be highlighted within the Installer menu. Press
down to highlight Single Feed Mode within the menu.
6. Press the right arrow once to turn Single Feed Mode to ‘ON’.
7. Press the green button to Save Settings and the Single Feed Mode Caution
message will be displayed.
8. Your Sky±HD box is now ready to be rebooted. When this happens:
a. Any current recordings will be stopped
b. Sky Anytime will be disabled
c. Autostandby will be enabled
To reboot your box, press select, but please allow a little time for this to happen.
TV
SAT
FM-DAB
To Next Page
Loading...
