0–37% charged 38–62% charged 63–87%
charged 88–100% charged
11 Skydio X2 - User guide © 2021 Skydio, Inc. All rights reserved.
GETTING STARTED / CHARGING
YOUR SYSTEM
Skydio
Enterprise Controller
How to charge
Connect your Skydio Enterprise Controller to
the provided USB charging cable and 65W
adaptor. You may also use the 100W
adaptor that comes included with the X2
Dual Charger, or any adaptor that is 18W or
above, to charge your controller.
• The controller will boot up and the LEDs on
the front of the controller will begin to flash
blue when charging, as well as a single LED
next to the USB-C charging port. You will
also see a charge level
displayed on the controller screen.
• When charging has completed, the LEDs
will show solid blue for 1 minute and then
power OFF.
NOTE: The Skydio Enterprise Controller
supports charging while in use, including
flying X2.
Skydio Enterprise
Controller Charge Levels
When the controller is powered on or
charging, the LEDs on the front of the
controller will indicate the current state of
charge. When the controller is powered off,
you can view the controller’s state of charge
by tapping on the power button to light up
the LEDs.
To Next Page
Loading...
