Skydroid MX450 - Page 4

Skydroid drone equips with smart baeries
1. DO NOT disassemble or reassemble the baery!
2. DO NOT short-circuit the baery!
3. DO NOT use it next to the heat sources!
4. DO NOT put the baery in water or make it wet!
5. DO NOT charge near fire or under sunlight!
6. DO NOT insert nails into the baery, hit or step on it with your feet!
7. DO NOT impact or throwing!
8. DO NOT use it under severe damage or deformation!
9. DO NOT solder directly on the baery!
10. Reverse charging or over-discharge is prohibited!
11. Reverse charging or reverse connection is prohibited!
12. DO NOT connect the baery to an ordinary charging socket or car cigaree
lighter!
13. DO NOT use on non-designated equipment!
14. DO NOT mix use with disposable baeries and this baery!
15. DO NOT exceed the specified charging time!
16. DO NOT put the baery in the microwave or high-pressure container!
17. DO NOT use or put the baery in the sun!
18. DO NOT use it in places with strong interference (high-voltage lines, power
stations, along the railway, base stations, signal transmission towers, etc.)!
19. DO NOT use in the environment below 0°C and above 45°C!
20. DO NOT use it and send it back to the seller when the baery is in use and
comes out an unpleasant smell or abnormal situation!
21. Keep away from the reach of children!
22. Use the oicial charger and follow the charging requirements!
• If you do not plan to use the product for a long time, please charge the baery
above 12v. If the voltage is higher than 13v, the baery will automatically start to
discharge to 11.55V after two days. Keeping around 11.55V can increase the baery
life.
• Please use the professional charger provided by Skydroid to charge the baery.
• Use a current below 5C for discharging, and the discharging time should not be
too long to avoid damage to the baery due to over-discharge.
• Do not charge in a flammable and explosive environment to prevent fire.
• The baery needs to be charged after being stored for more than three months
to maintain the voltage and ensure its expected life.