Skyjack SJ 6826RT - Platform Control Console Functions

SJRT Compact Series
Engine Powered December 2007 Page 15
TM
Section 2 - Familiarization Control Functions
It is the responsibility of the operator to read, completely understand and follow all instructions and warnings
contained in this operating manual and on the aerial platform.
FAMILIARIZATIONFAMILIARIZATION
2.2-9a Platform Control Console with Rotary
Switches (If Equipped)
This removable control console is mounted at the right
front of the platform. It contains the following controls:
2
9
1
3
7
8
6
5
4
Figure 2-8a. Platform Control Console with Rotary
Switches
1. Lift/Torque/Drive Switch - This selector switch,
when in “
” lift position, allows lift functions
to operate. When in “
” low speed position, it
allows drive functions to operate at low speed and
maximum torque when climbing grades and on
rough terrain. When in “
” high speed position,
it allows drive functions to operate at high speed
with minimum torque.
2. Engine Start Pushbutton - This “ ” pushbutton
energizes the engine starter motor.
NOTE
The engine start pushbutton is interlocked
with the oil pressure switch. If engine stalls
or does not start immediately, this button
will not work for a few seconds while oil
pressure bleeds off.
3. Horn Pushbutton - This “ ” pushbutton sounds
an automotive-type horn.
4. Emergency Stop Button - This button
“
”, when depressed, disconnects power to the
control circuit.
5. Power Indicator Light - This light glows when “
” platform is selected from the platform/engine/
base key switch on the base control console. It
also glows when both emergency stop buttons on
the platform control console and the base control
console are pulled out.
6. Choke Pushbutton (Dual Fuel) - This pushbutton
sets the “
” choke for starting a cold gasoline/
propane engine.
Glow Plug Pushbutton (Diesel) - This pushbutton
energizes the “
” glow plugs to aid in starting a
cold diesel engine.
7. Low/High Throttle Switch - This rotary switch
allows selection between “
” low and “ ”
high engine throttle speeds.
8. Lift/Drive/Steer Controller - This one-hand lever
controls lift/drive and steer motions. Internal
springs return it to neutral when controller is
released. The rocker switch on top of controller
handle controls steering function.
9. Lift/Drive/Steer Enable Trigger Switch - This
momentary “ ” switch energizes the controller.
It must be held depressed continuously while
engaging either the lift/drive or steer functions.