SJ45 AJ+, SJ60 AJ+ 238264AAA
45
Visual and daily maintenance inspections Section 4 – Inspections Before Operation
1
4
2
3
4.2-7 Base
Do the inspection that follows:
1
2
Axles
▪
Make sure the front
1
and rear
2
axles are
correctly attached.
▪
Make sure there are no loose or missing parts.
▪
Make sure all the ttings and hose connections
are tight.
▪
Make sure there is no sign of hydraulic
leakage.
3
Tie rod
▪
Make sure there are no loose or missing parts.
▪
Make sure the tie rod end studs are attached
and tight.
▪
Make sure there is no visible damage.
4
Oscillating cylinders
▪
Make sure the cylinder assembly that
oscillates is correctly attached, and there are
no visible spaces.
▪
Make sure there are no loose or missing parts.
▪
Make sure all the ttings and hose connections
are tight.
▪
Make sure there is no sign of hydraulic
leakage.
NOTE
The oscillating axle is locked when the MEWP is
in the elevated travel position or at the elevated
travel speed.
To order go to Discount-Equipment.com
To Next Page
Loading...
Need help?
General
