SJ46AJ SJ51AJ SJ63AJ
December 2007 Page 25
It is the responsibility of the operator to read, completely understand and follow all
instructions and warnings contained in this operating manual and on the MEWP.
FAMILIARIZATION
2.3-9 Control Compartment
- Ensure all compartment latches are
secure and in proper working order.
• Base Control Console
- Ensure all switches are returned to their
neutral positions.
- Ensure there are no loose or missing
parts and there is no visible damage.
• Hydraulic Tank
- Ensure hydraulic ller cap is secure.
- Ensure tank shows no visible damage
and no evidence of hydraulic leakage.
• Hydraulic Oil
- Be sure that the boom is in the stowed
position, and then visually inspect the
sight gauge located on the side of the
hydraulic oil tank for SJ46AJ/SJ51AJ
and on the front of the hydraulic oil tank
for SJ63AJ.
- The hydraulic oil level should be between
the minimum and maximum marks on
the sight glass. Add oil as needed. Refer
to Table 4.2b for recommended oil type.
• Brake and Main Manifolds
- Ensure all ttings and hoses are properly
tightened and there is no evidence of
hydraulic leakage.
- Ensure there are no loose wires or
missing fasteners.
• Emergency Power Unit
- Ensure there are no loose or missing
parts and there is no visible damage.
- Ensure there are no loose wires or
missing fasteners.
- Ensure all ttings and hoses are properly
tightened and there is no evidence of
hydraulic leakage.
• Fuel Tank
IMPORTANT
Before using your MEWP ensure there
is enough fuel for expected use.
- Ensure fuel ller cap is secure.
- Ensure tank shows no visible damage
and no evidence of fuel leakage.
• Fuel Leaks
- Ensure that there no fuel leaks.
DANGER
Engine fuels are combustible. Inspect
the MEWP in an open, well-ventilated
area away from heaters, sparks and
ames. Always have an approved re
extinguisher within easy reach.
- Ensure fuel tank, shutoff valve, hoses and
ttings show no visible damage and no
evidence of fuel leakage.
Section 2 - Familiarization Visual & Maintenance Inspection