SJ46AJ SJ51AJ SJ63AJ
December 2007 Page 35
It is the responsibility of the operator to read, completely understand and follow all
instructions and warnings contained in this operating manual and on the MEWP.
FAMILIARIZATION
6. On platform control console, select “ ”
on position from engine enable switch.
7. Select “ ” start position from engine
start/on/off switch to start engine.
8. Dismount from platform.
9. On base control console, attempt to
activate each boom and platform switch
while holding function enable switch.
Result: All boom and platform functions
should not operate while holding function
enable switch.
10. Push in “ ” emergency stop button to
turn engine off.
11. Pull out “ ” emergency stop button.
2.4-4 Platform Control Console
WARNING
Ensure that you maintain three points of
contact to mount/dismount platform.
1. Enter platform and close gate.
WARNING
DO NOT operate any control on platform
control console without proper fall
protection secured to designated location
in platform. Failure to avoid this hazard
could result in death or serious injury!
WARNING
Ensure that there are no personnel or
obstructions in test area and that there is
sufcient room for boom to swing.
• Test Platform Emergency Stop Light
1. On platform control console, pull out “ ”
emergency stop button.
Result: Emergency stop light should
continuously illuminate.
149432AA149432AA
At Platform Controls:
1. Pull out emergency stop button.
2. Depress and hold foot switch.
3. Activate emergency pump switch.
4. Activate desired boom function.
EMERGENCY LOWERING
PROCEDURE
Drive/Steer
Controller
Horn
Engine Start/On/Off
Switch
Emergency
Stop
Section 2 - Familiarization Function Tests
To Next Page
Loading...
