Page 18 December 2007
Rough Terrain Scissors
TM
Visual & Maintenance Inspection Section 2 - Familiarization
It is the responsibility of the operator to read, completely understand and follow all instructions and warnings
contained in this operating manual and on the aerial platform.
FAMILIARIZATIONFAMILIARIZATION
- Ensure all bolts are properly tightened.
- Ensure all fittings and hoses are properly
tightened and there is no evidence of
hydraulic leakage.
• Radiator
- Ensure radiator is secure.
- Ensure there are no loose or missing
parts and there is no visible damage.
- Check coolant level and add as
needed.
• Muffler and Exhaust
- Ensure muffler and exhaust system are
properly secured, with no evidence of
damage.
• Engine Pivot Tray
- Ensure there are no loose or missing
parts and no visible damage to the engine
pivot tray. Ensure that both tray-securing
bolts are in place.
• Engine Oil Level
- Maintaining the engine components
is essential to good performance and
service life of the MEWP.
WARNING
Beware of hot engine components.
Check oil level on dipstick
- Oil level should be in the “safe” zone. Add
oil as needed.
• Fuel Shut-off Valve
- Ensure there are no loose or missing
parts and there is no visible damage.
• Engine Air Filter
- Ensure there are no loose or missing
parts and there is no visible damage.
• Fuel Leaks
Failure to detect and correct fuel leaks will
result in an unsafe condition. An explosion or
fuel fire may cause death or serious injury.
DANGER
Engine fuels are combustible. Inspect
the MEWP in an open, well-ventilated
area away from heaters, sparks and
flames. Always have an approved fire
extinguisher within easy reach.
Perform a visual inspection around the following
areas:
• hoses and fittings
• fuel pump
• fuel filter
Main Power
Disconnect Switch
Battery
Base Control
Console
Engine Air Filter
Hydraulic Pump
Radiator
Muffler and Exhaust
Engine
Fuel Shut-off Valve
Load/Tilt
Sensor
To Next Page
Loading...
Need help?
General
