Rough Terrain Scissors
December 2007 Page 25
Section 2 - Familiarization Function Tests
It is the responsibility of the operator to read, completely understand and follow all instructions and warnings
contained in this operating manual and on the aerial platform.
FAMILIARIZATIONFAMILIARIZATION
2.4 Function Tests
Function tests are designed to discover any malfunctions
before MEWP is put into service. The operator must
understand and follow step-by-step instructions to test
all MEWP functions.
IMPORTANT
Never use a malfunctioning MEWP. If
malfunctions are discovered, MEWP must
be tagged and placed out of service.
Repairs to MEWP may only be made by
a qualified service technician.
After repairs are completed, operator must perform a
pre-operation inspection and a series of function tests
again before putting MEWP into service.
Prior to performing function tests, be sure to read and
understand Section 3.8 - Start Operation.
2.4-1 Test Main Power Disconnect Switch
1. In engine compartment, turn main power
disconnect switch to “ ” off position.
Result: MEWP functions should not operate.
2.4-2 Base Control Console
WARNING
Ensure that you maintain three points of
contact when using the ladder to mount/
dismount platform.
1. Use the ladder of MEWP to access platform.
2. Close the gate.
3. On platform control console, push in “ ”
emergency stop button.
4. Use the ladder to dismount from platform.
5. Turn main power disconnect switch to “ ”on
position.
6. On base control console, pull out “ ”
emergency stop button.
Platform/Engine/Base
Key Switch
Emergency Stop Button
Main Power Disconnect
Switch
To Next Page
Loading...
Need help?
General
