Page 52 December 2007
Rough Terrain Scissors
TM
Refueling Procedure Section 3 - Operation
3.9-2 Propane
WARNING
Follow all local and federal regulations
for propane handling.
Removing a Propane Cylinder
1. Ensure engine and all systems are turned off and
emergency stop button is depressed.
2. Turn propane cylinder’s main valve clockwise to
shut off fuel supply to engine.
3. Start engine and allow it to stop naturally. Restart
engine to ensure fuel lines are empty.
4. Disconnect hose from empty propane
cylinder by detaching the coupling. Turn fitting
counterclockwise.
5. Loosen two propane cylinder straps by pulling
up on the metal clips. Disconnect straps from
hooks.
6. Remove the propane cylinder.
Installing a Propane Cylinder
1. Ensure engine and all systems are turned off and
emergency stop button is depressed.
2. Place propane cylinder on bracket or in
compartment.
3. Ensure metal peg on bracket or compartment is
inserted into propane cylinder rim.
4. Reconnect propane cylinder straps to hooks and
fasten tightly.
5. Attach coupler to propane cylinder and turn
clockwise to tighten fitting.
6. Apply soap water or neutral detergent to pipe
connection and cylinder.
7. Open valve 1/4 turn counterclockwise and check
for any gas leaks.
8. Wipe off soap water or detergent after inspection
is completed.
9. Open main valve fully if there are no leaks.
NOTE
The MEWP is now ready for use by an
authorized, qualified operator who has read
and completely understands all of Section 3
operations in this manual.
To Next Page
Loading...
Need help?
General
