SKYJACK, Page 29
Section 2 - Operation
August 2007
SJM & SJII Series
8. To Extend/Retract powered extension deck:
Ensure the emergency stop buttons on the base
control box (If Equipped) and the operator’s
console box are pulled out. Turn key to Lift
position with Lift/Off/Drive Select Switch. On the
powered extension deck control box, activate the
Enable Switch (If Equipped), then push the
extension/retraction toggle switch to the “×”
(extend) position until desired extension is reached.
Release switch to stop.
To retract the platform, ensure the emergency stop
button is pulled out and turn key to Lift position
with Lift/Off/Drive Select Switch. On the powered
extension deck control box, activate the Enable
Switch (If Equipped), then push the extension/
retraction toggle switch to the “Ø ” (retract)
position until desired extension is reached.
Release switch to stop.
Note
On machines manufactured 3/96 and since, the extension
platform MUST be retracted to 3 ft. extension or less
before driving. On machines manufactured 2/96 and
prior
, the extension platform MUST be fully retracted
before driving. On machines equipped with scissor
guards, the extension platform MUST be fully retracted
to fully lower the platform.
Warning
To protect against unintended movement of the aerial
platform, push in the emergency stop button after
you have arrived at your desired location or elevation.
2-24. Shutdown Procedure
1. Completely lower the platform.
2. Turn Key Switch to “OFF” position. Remove key.
3. Push Emergency Stop Button(s) in.
4. Rotate Emergency Main Power Disconnect Switch
to “OFF” position.
5. Push in Emergency Stop Button located on Base
Control Box (If Equipped).
• Push or pull the controller handle forward or
backward to the desired speed and direction of
platform travel.
• Return the joystick to the neutral center position
to stop. Release the Enable trigger switch.
To Steer:
• Select “ON” position with On/Off Select Key Switch
or select “PLATFORM” position with Platform/Off/
Base Select Key Switch (If Equipped).
• Activate and hold the Enable trigger switch (by
squeezing it towards the joystick) (If Equipped).
• Press the rocker on top of the controller handle in
the direction you wish to steer
.
Warning
If the machine does not drive when elevated
• Disengage the drive controller.
• Lower the platform immediately.
• Ensure the machine is being operated on a
compacted, firm level surface or the tilt sensor
will disable some or all functions.
6. To Sound the Horn:
Depress the horn push-button located on the side
of the operator’s platform control box.
7. To Extend/Retract a manual extension deck:
Warning
Ensure that there are no personnel or obstructions in
the path of travel, including blind spots
Remove the locking pin(s) and push/pull the
extension deck using the sliding handrails or push-
bar. Reinsert the locking pin(s), upon full retraction
or extension to prevent accidental movement of
the manual extension platform during travel or
transport.
To Next Page
