The sensor must be programmed to the Household Alert
®
Long Range
Receiver before they can communication. You may program the sensor
to one of the 4 zones. Follow the instructions below:
1. Plug in an AC adapter to the receiver.
2. The green LED will be on indicating it is turned on.
3. Open the back cover and there is a learn button. Press and hold this
learn button for 5 seconds, until both green LED and zone 1 red LED
flash. You may now release the learn button.
4. If you would like to program the sensor to zone 1, activate the
sensor while the zone 1 red LED is flashing. Activate the Water
Sensor by placing the sensor portion into the water.
5. If you would like to program the sensor to other zones, press the
learn button again, until the red LED flashes at the zone you want to
program the sensor to, then activate the sensor.
6. Once the sensor is programmed, the green LED will be steadily on
and none of the red zone LEDs will be on.
Note: Each zone can program up to 4 sensors. If you try to program a
fifth sensor into a zone, the first programmed sensor will be erased.
1. INTRODUCTION
Wireless Water Alert
Model WA-434RTL
The Wireless Water Alert is designed to detect water overflow, water
leakage, or rising water, such as the water level of your bathtub. When
water is detected, the receiver will flash along with alert beeping or alarm.
In this package, you should find a water sensor, a Household Alert
®
receiver, an adapter, 3V lithium battery (installed) and other mounting
accessories.
Please follow the instructions below to setup your water sensor and
the receiver.
Adapter
Mounting
Accessories
Water Sensor
Plug in the adapter to the receiver
2. PROGRAMMING
Household Alert
®
Long Range Receiver
Learn Button
Sensor portion being submerged
into the water, Receiver zone LED
stops flashing.
2. PROGRAMMING (CONT)
Erasing a sensor
You cannot erase a specific sensor. You must erase all sensors from
the receiver, then program the ones you would like to keep. To erase
all the sensors from the receiver:
1. Remove the adapter from the receiver.
2. Open the back cover, press and hold the learn button. Do not
release the learn button until step 4.
3. While holding onto the learn button, plug in the adapter to the receiver.
4. You may release the learn button when the LEDs on the receiver are on.
5. You have erased all sensors from the receiver.
Transmitter
portion
Sensor
portion
Note: The transmitter
portion should never be
submerged in water.
3. INSTALLATION
A clean smooth surface is required to mount the water sensor securely.
Mount the transmitter portion and sensor portion to the appropriate
location with double sided foam tape respectively.
If the mounting surface is not
smooth or clean enough for the
doubled sided tape, you may
screw the plastic plate onto the
surface, which then provides a
smooth & clean surface for the
double sided tape.
Always mount the transmitter
portion at least 6 inches
above the sensor portion.
Rough
surface
Plastic plate
with screws
Double sided
tape
Water
Sensor
Testing:
After mounting the sensor, test the sensor by placing it into the water
and removing it from the water. The Receiver should respond in the
same way as described above.
Test Sensor
After learning the sensor to the receiver, you may test the communication
by placing the sensor into the water and removing it from the water.
When the sensor is not in the water, the
receiver will not beep.
When the sensor is in the water, the receiver
will beep and zone LED will flash.
1) Zone LED of this sensor will flash
2) Beeping according to the zone number [Alert Notification Switch is set
to "Alert"]. 1 beep for zone 1, 2 beeps for zone 2 etc, until the sensor
is removed from water.
To Next Page
Need help?
General
