SPECIAL FEATURES
· 04
D200
Internal Independent Lithium Battery Balancer
SKYRC D200 employs an individual-cell-voltage balancer. It isn't necessary to connect an
external balancer for balance charging.
Balancing Individual Cells Battery Discharging
During the process of discharging, SKYRC D200 can monitor and balance each cell of
the battery individually. Error message will be indicated and the process will be ended
automatically if the voltage of any single one cell is abnormal.
Adaptable to Various Type of Lithium Battery
SKYRC D200 is adaptable to various types of lithium batteries, such as LiPo, LiIon and
the new LiFe series of batteries.
LiHV Mode Available
The additional LiHV mode is able to charge the new generation of LiPo batteries with an
end of charge voltage 4.35 V.
Smart Phone Control via Wi-Fi Module (both iOS and Android)
Finally, your charger gets its own apps. This charger can be controlled and operated by
smart phones via Wi-Fi module(option part SK-600075).
Battery Memory (Data Store/Load)
The charger can store up to 20 different charge/discharge profiles for each channel. You
can keep the data pertaining to program setting of the battery of continuous charging or
discharging. Users can call out these data at any time without any special program
setting.
Terminal Voltage Control(TVC)
The charger allows user to change the end voltage. (for expert user only)
PC Control Software “Charge Master”
The free “Charge Master” software gives you unparalleled ability to operate the charger
through the computer. You can monitor pack voltage, cell voltage and other data during
the charging, view charge date in real-time graphs. And you can initiate, control charging
and update firmware from “Charge Master”.
With “Charger Master” and one computer, you could operate and update two channels
simultaneously.
Soldering Iron
Digital display shows temperature range from 200°C-450°C(392°F-842°F). Two soldering
tips, pencil tip and chisel tip are included. Power rate up to 60 watts.
To Next Page
Loading...
