Revised 3/17/05 Page 5 of 5
FREQUENCY (DISTANCE) ADJUSTMENT PROCEDURE
RECEIVER ADJUSTMENT
1. To adjust at the receiver, use a small slotted screwdriver. Turn the
adjustment (ADJ) screw counter-clockwise about 5° or maximum of 1/8 turn.
This should correct the distance problem.
2. If that does not correct the problem, return adjustment screw to original
position and then turn adjustment screw clockwise.
This adjustment is like tuning your radio. If you keep turning the adjustment
screw, in either direction, you will go past the proper setting (tuning).
SPECIFICATIONS
BATTERIES: Transmitter 12V - (A23)
Remote Receiver 6V - 4 ea. AA 1.5 Alkaline FCC ID No.'s: transmitter - K9L1002TX; receiver - K9L300IRX
Operating Frequency: 303.8 MHZ Canadian ISC ID No.'s: transmitter - 2439 102 728; receiver - 2439 102 728A
FOR TECHNICAL SERVICE, CALL
: U. S. INQUIRIES CANADIAN INQUIRIES
888/672-8929 or 877/472-3923
260/459-1703
WEBSITE: skytechsystem.com
MANUFACTURED EXCLUSIVELY FOR SKYTECH II, INC.
FCC REQUIREMENTS
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY
UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.
WARRANTY
All warranty information is listed on the warranty sheet packed with this product. If you did not
receive this warranty sheet, please contact Skytech Systems, Inc. at the following:
9230 Conservation Way, Fort Wayne, IN 46809
(888) 672-8929 or (260) 459-1703
LEARN
ADJ.
Wire terminals
Remote Receiver
Frequency adjusting
access hole
Learning
button
REMOTE
OFF
f i r e - p a r t s . c o m
To Previous Page
Loading...
Need help?
Battery
Power
