Skytech SP1001H/L-TH User Manual

_________________________________________________________________________________________________
Rev. 12/26/13 Page 1 of 5
Skytech SP1001H/L-TH
MODEL: SP1001H/L-TH
OPERATING INSTRUCTIONS
INTRODUCTION
This transmitter operating range is approximately 20-feet. The transmitter operates on one of 1,048,576 security codes that are
programmed into the transmitter at the factory; this transmitter operates on radio frequencies with non-directional signals. The receiver
for this transmitter is built into the AF-4000MOD-1 module.
TRANSMITTER
The transmitter operates on (2) 1.5V AAA batteries. It is recommended that
ALKALINE batteries always be used for longer battery life and maximum
operational performance.
Before using the transmitter, install the (2) AAA transmitter batteries into the
battery compartment. (Use caution that batteries are installed in the proper
direction)
KEY SETTINGS
1. ON H/L - Turns unit to ON and operates the
flame control HI or LO.
2. OFF
CONTINUOUS PILOT - Shuts the unit OFF and activates the
continuous pilot on feature
3. MODE - Changes unit from manual mode to
thermo mode.
4. SET - Sets temperature in thermo mode.
1. DISPLAY Indicates CURRENT room temperature
2.
0
F OR
0
C Indicates degrees Fahrenheit or Celsius
3. FLAME Indicates burner/valve in operation
4. ROOM Indicates remote is in THERMO operation
5. TEMP Appears during manual operation
6. SET Appears while setting the desired
temperature in the thermo operation
7. PILOT Appears in the Continuous Pilot mode
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS DO NOT
ATTEMPT TO OPERATE
ROOM
LCD - Liquid Crystal Di
TEMP
1
2
3
SET
4
5
6
PILOT
7
ON H/L
MODE
OFF
Continuous
Pilot
BUTTON
WALL CLIP
SLOT
BATTERY
COMPARTMENT
FRONT BACK
SET
ON H/L
BUTTON
MODE
BUTTON
SET
BUTTON
Continuous
Pilot
ROOM
TEMP
SET
PILOT
OFF
ON H/L
MODE
OFF
Continuous
Pilot
SET
1
2
3
4

Skytech SP1001H/L-TH Specifications

General

Brand	Skytech
Model	SP1001H/L-TH
Category	Remote Control
Language	English