SETTING
0
F /
0
C SCALE
The factory setting for temperature is
0
F. To change this setting to
0
C,
first
• Press the ON H/L key and the OFF CONTINUOUS PILOT key on
the transmitter at the same time. This will change from
0
F to
0
C.
Follow this same procedure to change from
0
C back to
0
F.
MANUAL FUNCTION
To operate the system in the manual “MODE” do the following.
ON – HI FLAME OPERATION
Press and release the ON H/L key the appliance flame will come ON
and flame on HI.
During this time the LCD screen will show HI, after 3 seconds the LCD
screen will default to display room temperature and the word TEMP will
show. (Flame icon will appear on the LCD screen in ON mode)
ON – LO FLAME OPERATION
Press and release the ON H/L key the appliance flame will stay ON and
flame on LO.
During this time the LCD screen will show LO, after 3 seconds the LCD
screen will default to display room temperature and the word TEMP will
show. (Flame icon will appear on the LCD screen in ON mode)
NOTE: If this SP1001H/LTH transmitter is used with the DC motor
drive HI/LO flame control, press and hold the ON H/L key to raise
or lower the flame height.
OFF OPERATION
Press the OFF Continuous Pilot key and the appliance flame will shut
off. During this time the LCD screen will show OF, after 3 seconds the
LCD screen will default to display room temperature and the word
“TEMP” will also show on the screen. (Flame icon will not appear on
the LCD screen in OFF mode)
THERMOSTAT FUNCTION
SETTING DESIRED ROOM TEMPERATURE
This remote control system can be thermostatically controlled when the
transmitter is in the THERMO mode. To set the THERMO MODE and
DESIRED room temperature,
Press the MODE key until the LCD screen shows the word ROOM, then
the remote is in the thermostatic mode.
NOTE: When the word ROOM is displayed on the screen the
transmitter is in the thermo mode.
To Next Page
Loading...
Need help?
General
