After the module emits the beep press ANY button on the transmitter and release. The module will emit several beeps indicating that
the transmitter’s code has been accepted into the module.
The microprocessor that controls the security code matching procedure is controlled by a timing function. If you are unsuccessful in
matching the security code on the first attempt, wait 1 - 2 minutes before trying again--this delay allows the microprocessor to reset its
timer circuitry--and try up to two or three more times.
BATTERY LIFE
Life expectancy of alkaline batteries in the SP1001H/LTH should be at least 12 months. Check and replace transmitter batteries
annually. When the transmitter no longer operates the remote receiver from a distance it did previously (i.e., the transmitter's range has
decreased) or the remote receiver does not function the transmitter batteries should be checked. The transmitter should operate with as
little as 2.5 volts battery power.
SPECIFICATIONS
BATTERIES: Transmitter (2) 1.5 volt AAA t bateries
FCC ID No.'s: transmitter - K9LSP1001TH
Operating Frequency: 303.8 MHZ Canadian IC ID No.'s: transmitter – 2439A-SP1001TH
FOR TECHNICAL SERVICE, CALL:
U. S. INQUIRIES CANADIAN INQUIRIES
(855) 498-8324 or (260) 459-1703 (877) 472-3923
For Sales: (888) 672-8929
WEBSITE: skytechpg.com
MANUFACTURED EXCLUSIVELY FOR SKYTECH II, INC.
FCC REQUIREMENTS
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY
UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.
To Next Page
Loading...
Need help?
General
