CDP-300 Installation Manual
Document Rev. 01.006 DOC0449 Page 20 of 31
Restricted Proprietary and Confidential Information
4 ELECTRICAL INSTALLATION
4.1 GENERAL
This section contains the information required to complete the electrical connections in a CDP-300 installation.
Included are diagrams and tables that call out and list the pin locations of the connectors used in the installation
as well as system wiring diagrams with installation notes.
When installing the CDP-300, the installer shall have a working knowledge of aircraft electronics installation and
be a holder of either an FAA Repairman’s Certificate or a Transport Canada equivalent. All installations should
meet the requirements of FAA advisory circular AC43.13-1B.
4.2 LINE FUNCTIONS
This section describes the pin layout of the CDP-300 DB-15 and DB-9 connector.
4.2.1 CDP-300 DB-15 CONNECTOR PIN-OUT.
Table 7 – CDP-300 DB-15 Connector Pin Descriptions
Ground sinking output used for buzzer activation.
Reserved for future use - Do not connect
Reserved for future use - Do not connect
RX line of RS-232 Databus to DVI-300
IMPORTANT NOTICE:
All system interconnect cables must be connected before power is applied to the system.
The document reference is online, please check the correspondence between the online documentation and the printed version.
To Next Page
Loading...
Need help?
General